Distance Adjust - Adjusting The Length Of Cut Line Segments - GRAPHTEC FC4100 series User Manual

DISTANCE ADJUST - Adjusting the Length of Cut Line Segments

The actual length of cut line segments may vary according to the thickness of the media being
used. In this case, use the DISTANCE ADJUST function to correct the distance.
Each of the DISTANCE ADJUST settings represent a percentage of two meter distance along the
X or Y-axis. Consequently, setting the DISTANCE AJUST Setting for the X-axis to +0.5%
increases the X-axis by 1 mm.
Press the MENU key to select MENU mode.
Press the NEXT key.
Press the NEXT key again.
Press the NEXT key again.
Press the F4 key to select OPTION 2.
Press the F3 key to select DISTANCE ADJUST .
Press the F2 key to correct the X-axis distance.
Press the F3 key to correct the Y-axis distance.
Press the F4 key to select RESET.
Press the UP or DOWN ARROW key to sequence
through the available choices.
Each value can be set in a range of -2.00% to +2.00%
in 0.05% steps.
Press the ENTER key to register your settings.
Press the MENU key to cancel MENU mode.
NOTE: Your DISTANCE CORRECTION setting is retained in the plotter's internal memory
even when the plotter is turned off.
Advanced Functions and Settings ♦ C4 - 36
OPTION 1>
OPTION 2>
DISTANCE ADJUST>
TEST>
DISTANCE ADJUST
X 0.00%z z
Y 0.00%
RESET>
DISTANCE ADJUST
X+2.00%
Y-2.00%z z
RESET>