Table of Contents
Advertisement
6.3 Setting the ORIGIN in HP-GL Mode
When the COMMAND setting is HP-GL, the origin point can be set to either the
lower left corner or center of the plotting area. When the COMMAND setting is GP-
GL, this parameter is not available.
S
1
2
3
4
5
6
7
A D V A NC E D F UN C T I O N S A N D O P E R A T I O N S : S et t i n g t h e O RI G I N i n H P - G L M o d e
P
ETTING
ROCEDURE
Press the MENU key.
Press the NEXT key until the following menu appears.
Press the F2 key (AREA PARAMETERS). The following menu appears.
Note: ORIGIN is only displayed when the COMMAND setting is HP-GL.
Press the F1 key (ORIGIN). The following menu appears.
The asterisk "*" indicates the currently selected setting. Press the F3 key to
select LOWER LEFT. Press the F4 key to select CENTER.
Press the ENTER key to register your settings.
Press the MENU key to return the plotter to Ready status.
• This setting is retained in the plotter's internal memory even when the power is
turned off.
• When the origin has been set to CENTER, the X- and Y-axis coordinate values
shown on the display panel represent the respective distances from the lower
left point of the effective cutting (plotting) area.
INTERFACE>
AREA PARAMETERS>
FUNCTION>
FUNCTION 2>
ORIGIN>
AREA>
EXPAND>
PAGE LENGTH>
ORIGIN POINT
LOWER LEFT*
CENTER
6-5
Advertisement
Table of Contents
