Table of Contents
Advertisement
6-6
6.4 Setting the Cutting/Plotting Area
The Upper Right (UR) and Lower Left (LL) functions are used to specify the
effective cutting/plotting area. Any data outside the specified cutting/plotting area
is disregarded. Note that setting of the cutting/plotting area also repositions the
origin point in accordance with the movement of the cutting/plotting area.
1
2
3
4
5
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : S e t ti n g th e C u t t i n g / P l o t t i n g A r ea
<When a cut sheet is loaded in the rear loading model>
For the front loading model, rotate the above figure 180 degrees.
S
P
ETTING
ROCEDURE
Press the MENU key.
Press the NEXT key until the following menu appears.
Press the F2 key (AREA PARAMETERS). The following menu appears.
Note: ORIGIN is only displayed when the COMMAND setting is HP-GL.
Press the F2 key (AREA). The following menu appears.
Use the POSITION keys to move the pen carriage to the desired lower-left
setting position.
Cutting/plotting is
performed in this
area only
Upper right
setting position
Lower left
setting
position
Previously cut design
INTERFACE>
AREA PARAMETERS>
FUNCTION 1>
FUNCTION 2>
ORIGIN>
AREA>
EXPAND>
PAGE LENGTH>
SET LOWER LEFT
DEFAULT>
X=
0 mm
Y=
0 mm
Advertisement
Table of Contents
