Table of Contents
Advertisement
8-4
• Cross-cut Force Setting (CROSS CUT PRESSURE)
This function sets the cutting force for the cross-cut operation.
The default value is 30, but the setting should be changed to suit the media
type.
Thin media:
Thick media: Increase the value.
• Enabling or Disabling the 1/2 Pen Setting (CHECK PEN)
Note: This function can only be specified for a 2-pen model.
This function checks whether the physical PEN 2 is actually mounted in the pen
station during the media detection operation on a 2-pen model.
When ENABLED is selected, a check is performed
When DISABLED is selected, a check is not performed. If DISABLED is
selected, always check that PEN 2 is mounted in the pen station before turning
on the power.
• Fan Suction Setting (FAN POWER)
This function sets the suction force used to affix media to the plotter.
Thin media:
Normal media: Normal
• Enabling/Disabling the Beep Setting (BEEP FOR KEY OPERATION)
This function selects whether to enable or disable the beep that is emitted
whenever a control panel key is pressed.
ON:
OFF: The beep does not sound.
• Enabling/Disabling Auto Registration Mark Recognition (MARK AUTO
SCAN)
This function specifies enablings/disabling Auto Registration Mark Recognition
by reading from plagged-in software.
ON: The registration marks are sensed automatically.
OFF: The registration marks are not sensed automatically.
CAUTION: If DISABLED was selected for the media or pinch roller sensors, be sure to
B AC K G RO U ND S E T T I NG S : D es c ri p t i o n o f t h e B a c kg ro u n d S e t t i n g s
Decrease the value.
Weak
The beep sounds.
specify the cutting or plotting area (see Section 6.4, "Setting the Cutting/Plot-
ting Area". If the cutting or plotting area is not specified, the blade tip and the
cutting mat may be damaged, and the pen carriage may strike the sides of the
plotter.
Advertisement
Table of Contents
