Removing And Replacing A Second Row Microphone - Cisco TelePresence System 3200 Use & Care Manual

Chapter 12 Field-Replaceable Unit Guide
Step 7 Pull the cable out through the hole and set the microphone aside.
Note
Pull the replacement microphone cable through the hole in the tabletop.
Step 8
From the underside of the tabletop, attach the microphone by screwing in the two screws.
Step 9
Run the microphone cable to the codec in a similar manner as the original cable and attach it to the
Step 10
appropriate connection on the codec.
If required, reattach the projector assembly and perform the first-time projector setup procedure
Step 11
See
Projector" section on page 10-14
Test the microphone by performing the procedures in the
Step 12
page

Removing and Replacing a Second Row Microphone

Make sure to retain all screws, brackets, and other parts during the disassembly.
Note
Remove the privacy panel from the following table top sections:
Step 1
•
•
Note
Remove the microphone from the table top section to be replaced. See
Step 2
of the microphone and its attachment hardware.
Disconnect the microphone from the audio/video expansion unit, route the cable through the table top
Step 3
section, and remove the microphone.
The microphone cable routes from the audio/video expansion unit to the table top section by way of the
cable gutters on the second row table. The gutters are behind the privacy panels that you removed in
Step
Step 4 If required, remove the cable cover for the right end privacy panel as shown in
cable ties that bundle the microphone cable with other cables.
Step 5 Insert the microphone cable into the hole in the table top and route the cable through the cable gutters
to the audio/video extension unit.
Connect the microphone cable to the audio/video extension unit.
Step 6
Reconnect the microphone to the new table top section.
Step 7
See
OL-14521-01
If you are replacing a microphone in the second row, you must also remove the privacy panel for
that
Chapter 8, "Assembling the Remaining Cisco TelePresence Elements"
10-13.
The table top section to be replaced
All table sections to the right of the table top section to be replaced
See Chapter 7, "Building the Second Row Table Assembly"
panels.
1.
Figure 7-38 for microphone installation instructions.
for more information.
"Setting Up the Microphones" section on
Replacing a Microphone—Part Number CTS-MIC
and the "Setting Up the
for expanded views of the privacy
Figure 7-38 for an expanded view
Figure 7-46
Cisco TelePresence System 3200
and remove
12-13