Cisco TelePresence System 3200 Use & Care Manual page 186

Setting Up CTS Components
Figure 10-6 Correct Camera Target Alignment—Left Display
•
•
Show All Camera Targets
•
Flipping the Video Image
•
Focus the Camera
•
•
•
•
•
Attaching the Camera Hood Assembly
•
Attach the top hood before attaching the bottom hood.
Note
Do not overtighten the screws, or use a power screwdriver to tighten the screws. In addition, make sure
Caution
that you use screws of the correct length (20 mm). Overtightening the screws, or using a screw that is
too long, can cause the plastic hoods to break.
Cisco TelePresence System 3200
10-10
Click Hide Camera Target to remove the alignment images.
Click Done when you complete the adjustment.
Click Show All Camera Targets to align each camera independent of the other cameras.
Click Flip Video on Each Display to display a mirror image—meaning to simulate the image that
attendees will see—for the selected screen(s). Use this feature to make sure all three cameras are
vertically aligned.
Place the small target on the table.
Click Setup, then click Show Focus Target.
Adjust the small target so that the green box encloses some of the patterns on the small target.
Adjust the focus ring on the camera lens so the lines on the target are in focus. The ring is labeled
"N – 8". The thumbscrew (or 0.9 mm Allen wrench) is used to unlock the focus ring.
Click Hide Focus Targets, then click Done when you complete the adjustment.
After you complete the camera adjustment, attach the camera hood assembly. See
Chapter 10 First-Time Setup
Red
Vertical line
Red plus
sign within
black cross
Red lines
Table
edge
Figure 10-7.
OL-14521-01