Conventions And Terminology; Tools And Equipment List - Cisco TelePresence System 3200 Use & Care Manual

Chapter 1 Overview
Step 2 Install and connect the PDUs for the display and first row table assembly. See
Chapter 9, "Routing Power and Signal Cables"
Power and Signal Cables"
Step 3 Connect the projector to the projector mounting bracket and connect the projector and bracket to the
table assembly. See
Elements"
Signal Cables"
Place the Cisco Unified IP Phone on the first row table and connect the phone cable. See
Step 4
Chapter 9, "Routing Power and Signal Cables"
Install the privacy panels for the first row table. See
Step 5
First Row Table Assembly."
Install the speaker boards and speakers. See
Step 6
Remaining Cisco TelePresence Elements."
Install the projector screen. Refer to the projector screen installation guide that is packaged with the
Step 7
assembly.
Step 8 Connect the power cables for the codecs, lighting and table leg power connections by completing
in Chapter 9, "Routing Power and Signal Cables."
Connect the signal cables for the first row table by completing
Step 9
Signal Cables."
Assemble the camera targets by completing
Step 10
Cisco TelePresence Elements."
Perform first-time setup using the instructions in
Step 11

Conventions and Terminology

•
•
Figure 1-2

Tools and Equipment List

To assemble the Cisco TelePresence System 3200, you need the following tools and equipment:
Uncrating and Unpacking:
•
OL-14521-01
to connect the cables.
Step 2 and
to connect the projector to the table assembly and
to connect the cables.
The directions left and right in this guide are synonymous with participant's left and participant's
right. They refer to the assembly as you face the Plasma displays.
Cable connections to the Codecs are labeled with a color-coded symbol system.
– A single dot on a green background indicates a center element.
– Two dots on a white background indicate a left element.
– Three dots on a red background indicate a right element.
Cable Connection Labeling System
Claw hammer or small pry bar
to install the PDUs and
Step 3 in Chapter 8, "Assembling the Remaining Cisco TelePresence
to connect the cable.
Step 15
Step 8 through
Step 15 in Chapter 8, "Assembling the Remaining
Chapter 10, "First-Time Setup."
Conventions and Terminology
Step 1 through
Step 4 in Chapter 9, "Routing
Step 4 in Chapter 9, "Routing Power and
through Step 18 in Chapter 6, "Building the
Step 10 in Chapter 8, "Assembling the
Step 5 in Chapter 9, "Routing Power and
Cisco TelePresence System 3200
Step 3 in
Step 4 in
Step 4
1-3