Powering On The System - Cisco TelePresence System 3200 Use & Care Manual

Field-Replaceable Unit Guide
Revised: July 28, 2008, OL-14521-01
This chapter describes the steps you perform to replace the field-replaceable units (FRUs) for the
Cisco TelePresence system and includes the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Powering On the System

Use this procedure for sections in this chapter that require you to power on the system.
If you replaced the primary codec, reconfigure the codec for the new MAC address in
Step 1
Cisco Unified Communications Manager by performing the following actions:
a.
OL-14521-01
Powering On the System, page 12-1
Replacing the Camera Cluster-Part Number CTS3K-CAM-CLST-G2, page 12-2
Replacing a Plasma Display-Part Number CTS-DISP-65-GEN2, page 12-4
Replacing a Speaker-Part Number CTS-LDSPKR, page 12-8
Replacing a Codec Unit-Part Number CTS-CODEC-PRI-G2 (Primary Codec) or
CTS-CODEC-SEC (Secondary Codec), page 12-10
Replacing a Microphone-Part Number CTS-MIC, page 12-12
Replacing a Light Fixture-Part Number CTS-LIGHT-FIXT, page 12-14
Replacing the Audio/Video Extension Unit-Part Number CTS-AV-EXP, page 12-15
Replacing the Auxiliary Control Unit-Part Number CTS-LIGHT-CTRL, page 12-16
Replacing the Cisco Unified IP Phone-Part Number CP-7975G-CTS, page 12-17
Replacing the Projector Lamp-Part Number CTS-PRJTR-BL-GEN1, page 12-17
Replacing the Projector-Part Number CTS-PRJTR-GEN1, page 12-18
Replacing a PDU-Part Number CTS-PWR-PDU, page 12-19
Replacing a Display Shelf, page 12-20
Replacing a First Row Table Top Section, page 12-22
Replacing a Second Row Table Top Section, page 12-24
Log in to Cisco Unified Communications Manager.
12
C H A P T E R
Cisco TelePresence System 3200
12-1