Cisco TelePresence System 3200 Use & Care Manual page 219

Chapter 12 Field-Replaceable Unit Guide
Make sure that the leg still supports both table top sections.
Note
Remove the draw bolts between the table top sections on the side that you moved. See
Step 8
"Building the First Row Table Assembly"
If required, reposition the table leg so that it fully supports both table sections.
Step 9
Move the table leg on the other side of the table top to allow access to the draw bolts, making sure that
Step 10
the leg still supports both table top sections.
Step 11 Remove the draw bolts between the table top sections on the side that you moved.
Separate the table top sections to create a space between the section to be replaced of approximately one
Step 12
inch (2.5 centimeters); this step allows you to remove the splines between the table top sections.
Tip Move the sections to the left and use the space created by the open table door.
Be sure that the legs support all table top sections and do not allow any of the sections to fall.
Caution
Remove the splines from the slot in the edges of the table top section.
Step 13
Remove the table top section from the table legs.
Step 14
Place the new table top section on the table legs.
Step 15
Place the splines in the slots on the edge of the new table top section.
Step 16
Press the table top sections together.
Step 17
Step 18 Insert the draw bolts and tighten them between the new table top section and the adjoining table top
sections. See
Attach the legs to the table top sections with the screws. See
Step 19
Assembly"
Reconnect the microphone to the new table top section.
Step 20
Route the microphone cable to the audio/video extension unit and connect the cable to the unit.
Step 21
See Figure 6-13
Close the table door.
Step 22
Step 23 If you removed the table door, replace the door.
See Figure 6-14
OL-14521-01
Chapter 6, "Building the First Row Table Assembly"
for the location of the table legs and screw attachment locations.
for microphone installation instructions.
for table door installation instructions.
Replacing a First Row Table Top Section
for the location of the draw bolts.
for the location of the draw bolts.
Chapter 6, "Building the First Row Table
Cisco TelePresence System 3200
Chapter 6,
12-23