Cisco TelePresence System 3200 Use & Care Manual page 16

Parts List
The display structures are unstable during assembly. Use caution, and support all structures as required.
Caution
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
The directions left and right refer to the assembly as you face the Plasma displays.
Note
Before you start to build the structure, make sure that the floor in the installation room is level. An
Note
uneven floor can make it difficult or, in severe cases, impossible to align the plasma displays after you
build the structure and mount the displays.
Step 1 Attach the Leveling feet to the Rear and Front Foot stabilizers.
Figure 2-1
Figure 2-9
Note
structure.
Cisco TelePresence System 3200
2-2
Leveling feet
3
4
shows the correct positioning of the display structure; keep this in mind as you build the
Chapter 2
2
Building the Display Assembly
OL-14521-01