Replacing A Display Shelf - Cisco TelePresence System 3200 Use & Care Manual

Replacing a Display Shelf

Note
Click Login.
Step 10
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 11
window) is Enabled/Up.
Choose System Restart to perform a software reset.
Step 12
Refer to the
information.
Replacing a Display Shelf
The display shelves are the table sections that sit directly below the display screens.
Required Information, Tools, and Equipment
To remove and replace a display shelf, you need the following tools:
•
•
A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts.
Tip
Make sure to retain all screws, connectors, and other parts during the disassembly.
Note
Removing and Replacing a Display Shelf Row Table Section
Power off the system by completing turning off the following units:
Step 1
•
•
•
Make sure all system power is turned off before beginning this disassembly.
Caution
Open the table door.
Step 2
Remove the Projector screen by performing one of the following actions:
Step 3
•
Cisco TelePresence System 3200
12-20
If your administrator has changed the user name or password, enter those values.
Cisco TelePresence System Administrator's Guide
Medium and large Phillips screwdriver
10 mm wrench
The two left PDUs on the left accessory cabinet
The single right PDU on the right accessory cabinet
The auxiliary control unit on the center display structure
If your projector screen is slightly recessed and uses black side trims, complete the following steps:
Remove the side trims from the edges of the display.
a.
Chapter 12 Field-Replaceable Unit Guide
for your software release for more
OL-14521-01