Replacing A Pdu-Part Number Cts-Pwr-Pdu - Cisco TelePresence System 3200 Use & Care Manual

Chapter 12 Field-Replaceable Unit Guide
Step 10 Reattach the power cable to the projector.
Reattach the serial cable to the auxiliary control unit.
Step 11
Power on the projector by turning on the power switch located on the back of the unit.
Step 12
Perform first-time setup procedures for the projector by completing the steps in the
Step 13
Projector" section on page
Replacing a PDU—Part Number CTS-PWR-PDU
There are seven PDUs in the following places:
•
•
•
•
•
On the PDU to be replaced, turn the power switch to Off and remove the plug from the wall receptacle.
Step 1
Remove any cables plugged into the PDU.
Step 2
Remove the PDU by performing one of the following steps:
Step 3
•
•
Attach the replacement PDU.
Step 4
Plug in the jumper cords that were removed and turn the power switch to the On position.
Step 5
Plug the PDU power cord into the wall receptacle.
Step 6
Open a browser on a computer connected to the network.
Step 7
Get the IP address for the system codec as follows:
Step 8
a.
Note
b.
c.
Step 9 Type in the IP address of the system codec. Log in to the system by entering the following information:
a.
b.
OL-14521-01
10-14.
Two PDUs attached to the left accessory cabinet
One PDU attached to the right accessory cabinet
One PDU attached to the underside of the first row tabletop, on the center privacy panel
One PDU in the cable gutter on the second row table section, Section 4 (second from the left)
One PDU in the cable gutter on the second row table section, Section 3 (second from the right)
Remove a PDU from the accessory cabinet or the first row center privacy panel by removing the
mounting screws.
Remove the PDU from the second row table section by removing the plastic knob screws on the
underside of the table, removing the privacy panel, and removing the PDU that is placed in the lower
cable gutter.
On the IP phone, locate Manual at the bottom of the screen and press the soft key.
If you cannot locate the Manual button, proceed to Step
Locate Info at the bottom of the screen and press the soft key.
Scroll down to the IP Address listing and copy the address.
In the Admin field, type admin.
In the Password field, type cisco.
Replacing a PDU—Part Number CTS-PWR-PDU
"Setting Up the
b.
Cisco TelePresence System 3200
12-19