Conventions And Terminology - Cisco 3000 Use & Care Manual

Conventions and Terminology

c.
Install the codecs and connect the signal cables. See
Step 6
the Remaining Cisco TelePresence Elements"
"Routing Power and Signal Cables"
If you ordered a presentation codec, install this codec. Refer to the
Step 7
Options and Upgrade Guide
Install and connect the camera assembly. See
Step 8
Cisco TelePresence Elements"
and Signal Cables"
Step 9 Install and connect the PDUs. See
Cables"
cables.
Connect the projector to the projector bracket, and connect the projector and bracket to the table
Step 10
assembly. See
Elements"
Signal Cables"
Place the Cisco Unified IP Phone on the table and connect the phone cable. See
Step 11
"Routing Power and Signal Cables"
Step 12 Install the privacy panels. See
Cisco TelePresence Elements."
Step 13 Install the speaker boards and speakers. See
Remaining Cisco TelePresence Elements."
Step 14 Install the projector screen. Refer to the projector screen installation guide that is packaged with the
assembly.
Connect the power cables for the codecs, lighting and table leg power connections by completing
Step 15
in Chapter 8, "Routing Power and Signal Cables."
Assemble the camera targets by completing
Step 16
Cisco TelePresence Elements."
Perform first-time setup using the instructions in
Step 17
Conventions and Terminology
•
•
Cisco TelePresence System 3000
1-4
Install the I/O Modules for the table leg power and Ethernet connections and connect the Ethernet
cables. See Step 2 and Step 3
Elements" to install the I/O modules and cables and
Cables" to connect the Ethernet cables.
for more information.
to connect the camera cables.
to install the PDUs and
Step 4 and Step 5
to connect the projector to the table assembly and
to connect the cables.
The directions left and right in this guide are synonymous with participant's left and participant's
right. They refer to the assembly as you face the Plasma displays.
Cable connections to the Codecs are labeled with a color-coded symbol system.
– A single dot on a green background indicates a center element.
Two dots on a white background indicate a left element.
–
– Three dots on a red background indicate a right element.
in Chapter 7, "Assembling the Remaining Cisco TelePresence
Step 5
Step 11
to install the codecs and
to connect the signal cables between the codecs and plasma displays.
Step 1 in Chapter 7, "Assembling the Remaining
to install the camera assembly and
Step 1 through Step 3
Step 4 in Chapter 8, "Routing Power and Signal Cables"
in Chapter 7, "Assembling the Remaining Cisco TelePresence
to connect the cable.
Step 8 through Step 10 in
Step 16 through
Step 21 in Chapter 7, "Assembling the Remaining
Chapter 9, "First-Time Setup."
in Chapter 8, "Routing Power and Signal
through Step 13 in Chapter 7, "Assembling
Step 11 and Step 14
Cisco TelePresence Hardware
Step 12 in Chapter 8, "Routing Power
in Chapter 8, "Routing Power and Signal
Step 4 in Chapter 8, "Routing Power and
Step 5
Chapter 7, "Assembling the Remaining
Step 18 in Chapter 7, "Assembling the
Chapter 1 Overview
in Chapter 8,
to connect the
in Chapter 8,
Step 4
OL-14521-01