Ricoh J001 Service Manual page 574

Troubleshooting
Never attempt to clean the ink collection tank and reuse it.
SC993 High Voltage Leak
Have you turned the printer off?
This SC code was triggered by the accumulation of condensation or ink spillage onto the
transport belt.
Instructions
1. Open the top cover.
2. Visually inspect the transfer belt.
If you see condensation on the belt:
1. Switch off the printer and allow it to stand for at least two hours for the belt to dry.
2. After two hours switch the printer on and try again.
If you see ink on the belt, the belt must be cleaned by a service technician.
1. Open the top cover.
2. Visually inspect the transfer belt.
If you see condensation on the belt:
1. Make sure the paper tray is loaded with paper.
2. Push [Menu]> "Maintenance"> "De-Condensation" to feed three blank sheets of
paper through the paper path to absorb some of the condensation.
3. Inspect the belt again.
4. Repeat Steps 2 and 3 until you can no longer see condensation on the belt.
5. Switch the printer off and allow it to stand for at least two hours to dry.
6. After two hours switch the printer on and try again.
If you see ink on the belt, the belt must be cleaned by a service technician.
SC994 Vertical Motor Error
Have you cycled the machine off/on?
Instructions
1. Cycle the machine off/on.
2. Remove and reinstall the duplex unit.
3. Make sure that the releases levers on both ends of the duple unit are at the lock
position.
4. If these procedures do not solve the problem, swap the printer for repair.
SC999 Maintenance Stepping Motor Out of Home Position
Have you cycled the machine off/on?
Call Center Manual
CÓPIA NÃO CONTROLADA
25
CÓPIA NÃO CONTROLADA
J007/J010/J011