Ricoh J001 Service Manual page 394

Printer Display Summary
Status Monitor Message
Ink Collector Unit Almost
Full/Full
Ink Collector Unit Not
Detected
Network Interface Board
Error
No Paper/Tray Not
Detected (Bypass Tray)
No Paper/Tray Not
Detected (Tray 1)
No Response From
Printer
Out of Printable
Temperature Range
Paper Size
Mismatch/Paper Type
Mismatch (Auto Tray
Select)
Paper Size
Mismatch/Paper Type
Mismatch (Bypass Tray)
Paper Size
Mismatch/Paper Type
Mismatch (Tray 1)
Printer Error
J007/J010/J011
CÓPIA NÃO CONTROLADA
What It Means
unit must always be attached.
The ink collection unit is full and must be replaced.
Ink collection unit attached correctly?
Network interface card installed properly?
Bypass tray empty?
Load bypass tray, press [#Enter]
Tray 1 empty?
Paper loaded correctly?
Printer turned on?
Printer USB connection secure?
"USB" selected on the "Ports" sheet of the printer
driver?
Printer located where the temperature range is 10 to
° °
32 C (50 to 89.6 F)?
Turn the printer off and allow it to cool.
If humidity is higher than 54%, the high end of the
temperature range will be lower. The printer will not
return to standby mode until it has acclimated to the
room temperature. Wait for the Power lamp to stop
flashing
Tray specified for automatic selection loaded with the paper
size, paper type specified for the print job?
Can print with [Form Feed]? Push [Form Feed]> Select
Size/Type for Bypass> [#Enter]
Bypass tray loaded with paper size, paper type specified
for the print job?
Can print with [Form Feed]? Push [Form Feed]> Select
Size/Type for Bypass> [#Enter]
Tray 1 loaded with paper size, paper type specified for
the print job?
Can print with [Form Feed]? Push [Form Feed]> Select
Size/Type for Tray 1> [#Enter]
An error has occurred in the printer.
Cycle the printer off/on.
If the printer has just been moved from a cold location to
a warm room, wait at least 1 hour and try again.
4-8
CÓPIA NÃO CONTROLADA
SM