Ricoh J001 Service Manual page 330

Never handle the power cord with wet hands.
1. Remove the orange tape from around the power cord.
2. Plug the power cord into the power source.
3. Ground the power cord at the power source with the ground wire attached to
the plug.
4. Press the [Power] key.
The printer starts feeding ink into the ink tanks.
Two alternating messages are displayed with a progress bar to keep you
informed about the progress of ink filling.
Filling the ink tanks requires about 6 to 10 minutes.
Do not use the printer or touch any key on the operation panel until you see the
"Ready" message on the operation panel display.
As soon as the "Ready" message is displayed, the Power lamp lights and remains
on.
Never switch off the printer or disconnect the power cord while the tanks in
the print head are being filled for the first time.
If you accidentally turn the printer off while the ink tanks are filling, the printer
will dump the ink and empty the tanks. The next time the printer is turned on,
it will display the 'ink out' alert
You might hear a clicking sound while the ink tanks are filling. This is normal
and the noise will stop after a few minutes.
This printer has no mechanism to automatically detect tray paper size and
type.
SM
CÓPIA NÃO CONTROLADA
1-15
CÓPIA NÃO CONTROLADA
Installation Procedure
J007/J010/J011