Ricoh J001 Service Manual page 236

Event Service Center Call Response
Paper does not (2) Check the cassette to see if any
feed (cont.) paper remains.
(3) Reset the end fence.
Skewed paper
(1) Check the side fences.
feed
(2) Check the condition of the paper in
the cassette.
(3) Check the reverse guide.
(4) If Tray 2 is attached, check the rear
cover of the tray.
If procedures (1)-(4) do not solve the
problem, replace the paper cassette.
Jam on the (1) During duplex printing, especially
transport belt when printing on the back side
(2) Check the paper in use. Make sure
the paper is
- Not curled, bent
- Not to thick
- Not shedding coating
(3) Check the condition of the paper in
the cassette.
(4) Check the transport belt for dirt.
(5) Over Head Projector (OHP)
SM
CÓPIA NÃO CONTROLADA
Probable Cause
If a small number of sheets are Always load at least 100 sheets in the
loaded, the trailing edges of the paper cassette.
paper may ride over the top of the
end fence, and when the tray is
set, this presses the paper down
and pulls it out of the nip of the
paper feed rollers.
End fence is pushing against the Reset the end fence.
bottom of the stack.
Side fence does not move with Load the paper after positioning the side
reasonable force. fences.
When loading paper, make sure Remove the paper from the cassette
that the bottom sheet is not and reload it.
caught in the notch of the bottom
plate of the paper cassette.
The difference in the pressure of Paper feeds with the reverse guide
left-right transport is determined locked on both ends.
by the half-lock of the reverse
guide.
The difference in the transport Paper feeds with the rear cover locked
pressure on the left and right is on both ends.
determined by the half-lock of the
rear cover.
Side fence friction or fences Replace cassette (repair).
damaged.
Strength of attraction between Simple printing
belt and paper less, due to
spotted printing.
Duplex printing with compressed
characters
Paper/belt attraction deteriorated Use paper that is neither bent nor
curled.
Use only recommended paper.
Avoid using thick or coated paper.
When loading paper, make sure Remove the paper from the cassette
that the bottom sheet is not and reload it.
caught in the notch of the bottom
plate of the paper cassette.
Paper/belt attraction deteriorated Clean the transport belt.
Static electricity causes sheets to Remove the plain paper from the output
stick. tray. (Do not allow paper to mix.)
Do not allow OHP to stack more than 3
sheets.
CÓPIA NÃO CONTROLADA
Operator Action
Always load at least 100 sheets in the paper
cassette.
Reset the end fence.
Load the paper after positioning the side fences.
Remove the paper from the cassette and reload
it.
Paper feeds with the reverse guide locked on
both ends.
Paper feeds with the rear cover locked on both
ends.
Replace cassette (repair).
Simple printing
Duplex printing with compressed characters
Use paper that is neither bent nor curled.
Use only recommended paper.
Avoid using thick or coated paper.
Remove the paper from the cassette and reload
it.
Clean the transport belt.
Remove the plain paper from the output tray.
(Do not allow paper to mix.)
.
Do not allow OHP to stack more than 3 sheets
8-36
Problem Solution
Content User ST NR
X
X
X
X
X
X
X
X
X
X
X
X
X
X
J001/J003
C