Ricoh J001 Service Manual page 227

1-3 Wait for a few minutes, switch the printer on, and confirm
whether this error occurs again.
8.3.5 SUPPLYING INK
SERVICE CENTER CALL RESPONSE
Supplying ink.
The printer is warming up after being switched on, or doing
routine maintenance after a print cartridge has been replaced.
(1) After print head maintenance is finished, make sure that the
printer enters the "Ready" mode for normal operation.
8.3.6 PRINT CARTRIDGE EMPTY
SERVICE CENTER CALL RESPONSE
Ink near end.
The print cartridge is almost empty and momentarily printing will
no longer be possible.
Replace the print cartridge.
8.3.7 INK OUT
SERVICE CENTER CALL RESPONSE
Ink out.
The print cartridge is empty and printing is no longer possible.
Replace the print cartridge.
8.3.8 PRINT CARTRIDGE MISSING/INCORRECTLY SET
SERVICE CENTER CALL RESPONSE
Print cartridge loose.
Check the print cartridges and make sure none of them are
loose.
(1) Check all the print cartridges and make sure they are not
loose.
8.3.9 INK WASTE TANK NEEDS REPLACEMENT
SERVICE CENTER CALL RESPONSE
Ink Waste Tank Nearly Full.
The internal unit requires replacement.
SM
CÓPIA NÃO CONTROLADA
119.3°F).
PROBABLE CAUSE
Print head maintenance in progress.
Print head maintenance in progress.
PROBABLE CAUSE
A print cartridge has run out of ink during a print job.
A print cartridge has run out of ink during a print job.
PROBABLE CAUSE
A print cartridge has run out of ink during ink supply.
A print cartridge has run out of ink during a print job.
PROBABLE CAUSE
Print cartridges set incorrectly.
Damaged.
Print cartridges set incorrectly.
PROBABLE CAUSE
At power on, or during a print job, the printer detected that the
waste ink tank is nearly full.
8-27
CÓPIA NÃO CONTROLADA
confirm whether the printer is restored to normal
operation.
OPERATOR ACTION
Wait for the printer to enter the "Ready" mode after print
head maintenance is finished.
OPERATOR ACTION
Replace the print cartridge.
OPERATOR ACTION
Replace the print cartridge.
OPERATOR ACTION
Reset the print cartridges.
OPERATOR ACTION
J001/J003