Using the Operation Panel
Push [Online] to return to standby mode.
These procedures consume ink.
Flushing consumes more ink than cleaning.
Flush the print head nozzles only if the cleaning (the first procedure) does not
solve the problem.
To print a Nozzle Check Pattern
1.
Push [Menu], select "Maintenance", and push [#Enter].
2.
Select "Nozzle Check" and push [#Enter]
3.
Push [Online] to return to standby mode.
For more about how to use the Nozzle Check pattern to diagnose and correct
problems, see Section "4 Troubleshooting".
To restart an interrupted print job
Press the [Form Feed] key to start a print job again after you remove the cause of an error
(paper jam, for example). The [Job Reset] key flashes or lights and stays in this condition
for errors. For more, see Section "4. Troubleshooting".
To feed a sheet manually
1.
Set a sheet of paper in the bypass tray.
2.
Press the [Form Feed] key when the software application prompts you to do so.
To feed 1 blank sheet (cleaning):
1.
Push [Menu], select "Maintenance", and push [#Enter].
2.
Select "Paper Feed Test" and push [#Enter]
3.
Push [Online] to return to standby mode.
To feed 3 blank sheets (cleaning):
1.
Push [Menu], select "Maintenance", and push [#Enter].
2.
Select "De-condensation" and push [#Enter]
3.
Push [Online] to return to standby mode.
J007/J010/J011
CÓPIA NÃO CONTROLADA
1-6
CÓPIA NÃO CONTROLADA
SM