Ricoh J001 Service Manual page 240

Event Service Center Call Response
Tray 1 does not Press in gently on the paper cassette
pop out of the then raise the output tray to open the
printer after the cassette.
raising the
output tray.
Cover open (1) Check the Status Monitor for a
cover open message.
(2) Check the top cover for bending.
Repair.
Covers, fences Replace/repair
damaged
8.4.5 SPURIOUS NOISE -
HORIZONTAL DRIVE SYSTEM
Service Center Call
Event
Response
Rattling on right Repair.
side of printer.
Squeaking from Repair.
vertical drive
system Check the paper type.
Moaning sound Open and close the paper
cassette.
Squeaking Set several sheets of glossy
sound paper, not just 1 sheet.
Repair.
SM
CÓPIA NÃO CONTROLADA
Probable Cause
If the cassette is closed forcefully,
the cassette pawls may mesh with
the base frame.
Poor contact.
Interlock SW (top cover connector
disconnected).
Interlock SW (rear cover
connector disconnected).
Interlock SW harness
disconnected.
Interlock SW (top cover)
damaged.
Interlock SW (rear cover)
damaged.
Unapproved operation.
Probable Cause
Replace feed roller.
Foreign object in the printer, printer needs
lubrication.
Glossy paper can make a sound against
the bottom plate of the cassette.
Glossy paper may make a sound at
separation.
Shaft of the tension roller is squeaking.
CÓPIA NÃO CONTROLADA
Operator Action
Press in gently on the paper cassette Press in gently on the paper cassette then raise
then raise the output tray to open the the output tray to open the cassette.
cassette.
Check to see if the cover is open then Check to see if the cover is open then close it.
close it.
Reconnect connector.
Reconnect connector.
Replace interlock SW for top, rear covers.
Replace interlock SW (top cover).
Replace interlock SW (rear cover).
Replace/repair Replace/repair
Operator Action
Replace feed roller.
Lubricate the guide rod with oil and the rail with
grease.
Put 1 sheet of plain paper at the bottom Put 1 sheet of plain paper at the bottom of the
of the stack of glossy paper loaded in the stack of glossy paper loaded in the cassette.
cassette.
Remove the paper from the cassette and Remove the paper from the cassette and reload it.
reload it.
Lubricate shaft of tension roller.
8-40
Problem Solution
Content User ST
X
X
X
X
X
Problem Solution
Content User ST
X
X
X
X
X
J001/J003
NR
C
X
X
X
NR
C
X