Ricoh J001 Service Manual page 245

Service Center Call
Event
Response
Printing halts (1) Make sure the printer is not
before job
set to wait for OHP to dry.
finishes (2) After printing halts, check the
spooling operation on the
PC.
(3) If data transfer is not
progressing, check the
following.
- USB cable disconnected.
- Switch power off/on
- Cancel the print job on the
PC.
- Reboot the PC.
8.4.8 PAPER FEED
Service Center Call
Event
Response
Paper does not When feeding from Tray 1, even
feed after paper feeds to the
(Paper does not
prescribed position, paper does
arrive at trailing not arrive at the trailing edge
edge sensor.) sensor. Determine whether there
Tray 1 is no paper, or the paper has not
fed.
Paper does not When feeding from Tray 2, even
feed
after paper feeds to the
(Paper does not
prescribed position, paper does
arrive at trailing not arrive at the trailing edge
edge sensor.) sensor. Determine whether there
Tray 2 is no paper, or the paper has not
fed.
SM
CÓPIA NÃO CONTROLADA
Probable Cause
Check the spooling operation on the PC.
The PC may not be sending the data.
Probable Cause
- Paper out
- Paper slippage (non-feed)
- Tray set incorrectly.
- Paper out
- Paper slippage (non-feed)
- Tray set incorrectly.
- Rear cover of Tray 2 is open.
CÓPIA NÃO CONTROLADA
Operator Action
Switch printer power off/on Send the acquired information to the repair depot
for analysis.
Cancel the print job on the PC then
reboot.
If this error still occurs frequently, acquire
the printer information with the PC
Information Acquisition Tool.
Operator Action
- Load the paper cassette. - Load the paper cassette.
- Replace the paper. - Replace the paper.
- Open and close the paper cassette. - Open and close the paper cassette.
- Remove paper stack and load it again. - Remove paper stack and load it again.
- After removing the jam, press the - After removing the jam, press the [Paper Feed]
[Paper Feed] button on the printer. button on the printer.
- Load paper in Tray 2. - Load paper in Tray 2.
- Replace the paper. - Replace the paper.
- Open and close Tray 2. - Open and close Tray 2.
(1) If Tray 2 has paper loaded (1) If Tray 2 has paper loaded
- Remove paper stack and load it again. - Remove paper stack and load it again.
(2) When there is no paper in Tray 2 (2) When there is no paper in Tray 2
- Open the rear cover of Tray 2 and - Open the rear cover of Tray 2 and remove paper
remove paper jam. jam.
- After removing the jam, press the - After removing the jam, press the [Paper Feed]
[Paper Feed] button on the printer. button on the printer.
8-45
Problem Solution
Content User ST
X X
X X
X X
Problem Solution
Content User ST
X
X
J001/J003
NRC
X
X
X
NRC