Ricoh J001 Service Manual page 226

8.3 OTHER ERRORS
8.3.1 READY
SERVICE CENTER CALL RESPONSE
Online (Normal)
8.3.2 PREPARING/ADJUSTING - 1
SERVICE CENTER CALL RESPONSE
Preparing/Adjusting
The printer is warming up after being switched on, or after a print
cartridge has been replaced.
(1) After the printer has warmed up, make that it enters the
"Ready" mode for normal operation.
8.3.3 PREPARING/ADJUSTING - 2
SERVICE CENTER CALL RESPONSE
Preparing/Adjusting (Room Out of Temperature Range)
The printer cannot warm up to its normal operating temperature
because the room temperature is not within the allowed
temperature range for the printer.
(1) Damage.
1-1 Set up and use the printer in a room where the temperature
is well within the temperature range for operation of the
printer.
1-2 Printer internal temperature range; 1°C-46.5°C (33.8°F-
111.5°F).
(2) ST Descriptions
2-1 Operation impaired by other causes.
8.3.4 TEMPERATURE OUT OF RANGE
SERVICE CENTER CALL RESPONSE
Printer temperature out of range
The printer cannot warm up to its normal operating temperature
because the room temperature is not within the allowed
temperature range for the printer.
Do the following procedures and check the following points.
1-1 Switch the printer off.
1-2 Adjust the temperature of the room so it within the
temperature range approved for operation of the printer.
SM
CÓPIA NÃO CONTROLADA
PROBABLE CAUSE
---
PROBABLE CAUSE
The printer is warming up after being switched on, or after a
print cartridge has been replaced.
The printer is warming up after being switched on, or after a
print cartridge has been replaced.
PROBABLE CAUSE
The temperatures of the print heads, transport roller are out of
the temperature range for normal operation of the printer.
Print head temperature range; 1°C-41.5°C (33.8°F-106.7°F).
Adjust the ambient temperature so it is within the range of
operating temperature for the printer. Wait for the printer to go
online and be ready for normal operation after it has warmed.
up.
Control board defective.
PROBABLE CAUSE
(1) The temperatures of the print heads, transport roller are out
of the temperature range for normal operation of the printer.
(2) Damage.
1 Print head temperature range; 1°C-43.5°C (33.8°F-
110.3°F).
2 Transport roller temperature range; 1°C-48.5°C (33.8°F-
119.3°F).
8-26
CÓPIA NÃO CONTROLADA
OPERATOR ACTION
---
OPERATOR ACTION
Wait for the printer to enter the "Ready" mode after it has
warmed up.
OPERATOR ACTION
OPERATOR ACTION
1 Switch the printer off.
2 Adjust the ambient temperature so it is within the range
of operating temperature for the printer.
3 Wait for a few minutes, switch the printer on, then
J001/J003