Table of Contents
Advertisement
6.
Push [Online] to leave the Menu mode.
To adjust registration:
1.
Push [Menu] select "Maintenance", and push [#Enter].
2.
Select "Registration" and push [#Enter].
3.
Select "Pr. Test Sheet" and push [#Enter].
4.
Select the paper tray ("Tray 1 for example) and push [#Enter].
5.
Select the paper type and push [#Enter]. The test pattern for Registration prints.
1.
Fold the printed sheet in half lengthwise as shown above.
2.
Determine the 1st adjustment for the Read Direction.
After folding the test print in half parallel to its long edge as shown above, the
adjustment value in the Read Direction is the difference between the single vertical
line and cross vertical line that you can see when the folded sheet is held up to the
light.
If the difference is one calibration mark, for example, the adjustment is +1.0.
3.
Fold the sheet in half widthwise.
4.
Determine the 2nd adjustment for the Feed Direction.
The value read after folding the sheet widthwise, is the adjustment value for the
Feed Direction.
5.
Select "Adjustment" and push [#Enter].
6.
Select the paper tray and push [#Enter].
7.
Select the paper type and push [#Enter].
8.
Enter the adjustment for the Read Direction determined in Step 2 and push
[#Enter].
9.
Enter the adjustment for the Feed Direction determined in Step 4 and push
[#Enter]
J007/J010/J011
CÓPIA NÃO CONTROLADA
14
CÓPIA NÃO CONTROLADA
Call Center Manual
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
