Ricoh J001 Service Manual page 367

Component Removal
Push or to display "List/Test Print" and push [#Enter].
With "List/Test Print" displayed push [#Enter].
To print the Service Summary:
Confirm that paper is loaded in the paper tray.
Push [Menu].
Push or to display "List/Test Print" and push [#Enter].
Push or to display "Config. Page" and push [#Enter].
To print the Engine Summary Chart:
Do SP5200 (Print SMC). (Printing requires about 3 minutes.)
For more details about these status reports, please refer to the descriptions of
these reports at the end of Section "5. Service Tables".
1. Remove:
Right cover
Top cover
Rear cover
Crosspiece (J011 Only)
2. From the back of the printer, pull the corner [A] of the cover to disengage the
metal tab.
3. Slowly push the cover bracket from the right [B] about only 4 cm (1½") to the
left to disengage the hook below and lift it up.
Apply only enough force to slide the bracket off of its hook.
If you push too hard, the bracket may release suddenly from the frame and
the edge of the cover may shear components from the control board.
4. Touch a metal surface before you touch the control board.
5. Remove the control board [C] (
6. The NVRAM is on the bottom of the board. Turn the board over and lay it on a
flat surface.
J007/J010/J011
CÓPIA NÃO CONTROLADA
x8, x6).
3-20
CÓPIA NÃO CONTROLADA
SM