Ricoh J001 Service Manual page 128

TEST PRINT SAMPLE DESCRIPTION
Product Name
Shows the name of the product. Make sure the name of the product is correct
before you request service information.
Firmware Version (3 MB of data)
This is the number of the original version of the firmware. This is the number of the
firmware displayed in the printer driver after the operator clicks the "Maintenance"
and clicks the "About" button. The firmware version number in the Test Print
always changes after updating the firmware.
Update Version (1 MB of data)
This number may or may not change, depending on the market and other
requirements. This data is primarily for design use.
USB Select Mode
Shows the current selection for communication between the printer and the
computer. Two selections (set with the printer operation panel) are available.
System Bit Switch
The bit switches are set at the factory before shipping. No bit switch setting
adjustments are required in the field.
000000-000000-000000-000000
+
16 bits
SW1, SW2 SW3, SW4
Model Code
Shows the model code for these:
• J001
• J003
Serial Number
Shows the serial number of the printer.
Total Counter
Shows the total page count.
SC Log
Shows the 5 most recent SC codes given by the printer. For more, see Section "4.
Troubleshooting".
Jam Code Log
Shows the jam codes of the 5 most recent jam errors. For more, see the "Jam
Table" on the next page.
J001/J003
CÓPIA NÃO CONTROLADA
+
16 bits 16 bits
SW5, SW6
5-4
CÓPIA NÃO CONTROLADA
+ =
16 bits
64 bits
SW7, SW8
G707S900.WMF
SM