Ricoh J001 Service Manual page 389

Hide thumbs Also See for J001:
Table of Contents

Advertisement

Menu/Menu Item
De-condensation*
Feeds and ejects 3 blank sheets of paper to remove moisture inside
the machine.
System
Auto Continue
Determines how the printer handles a print job when the specified
paper size and type is not loaded in the tray.
Off: The job does not print if the specified paper size/type is not
loaded in the tray. The job will execute once the specified paper
size/type is loaded.
On: The job prints even if the specified paper size/type is not loaded
in the tray.
Sub Paper Size
Determines whether to print on A4 paper if LT size paper is specified
in the printer driver, and vice versa.
Default: Off
Unit of Measure
Determines the units of measure ("mm" or "in.") Default: mm
Energy Saver
Switches the energy saving function on/off. When this function is on,
the printer will automatically shut down some of its functions
automatically after it remains idle for the prescribed amount of time.
The "E. Saver Timer" can be set for 5, 15, 30, 35, 60 min.
Once the printer enters the energy save mode, it will require some
time to recover full operation once it receives a print job.
Notify by Email*
Determines whether a notification is sent to a specified email
address when a printer error occurs. Be sure to cycle the printer
off/on after doing this setting.
Page Size
Determines the default paper size. (The size selected automatically
in the printer driver.) Presents a variety of standard NA/EU paper
sizes.
Ink CU Replace*
Sets the ink storage counter after the ink collection unit is replaced.
Host Interface
I/O Timeout
Determines how long the printer waits for the interface to respond.
After the specified time elapses, the printer can receive data from
another interface. If the specified time is too short, a timeout might
occur while a data transfer is in progress. If this occurs, the print job
will be interrupted by a new job from another interface. Default: 15
sec.
Network Setup
Use to do the network settings.
Setting
DHCP
IP Address
Subnet Mask
SM
CÓPIA NÃO CONTROLADA
Function
Default
On
0.0.0.0
0.0.0.0
4-3
CÓPIA NÃO CONTROLADA
Printer Display Summary
J007/J010/J011

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

J010J011J003J006J007

Table of Contents