Ricoh J001 Service Manual page 337

Options
5. Position the 500-Sheet Paper Tray paper tray where the printer will be set up.
6. Mount the cover on the paper tray.
7. Align the connection point holes in the bottom of the printer with the pegs of
the paper tray while you hold the printer as shown.
8. Slowly set the printer on top of the paper tray.
Load Paper in the Paper Feed Unit
1. Raise the paper tray slightly and pull it toward you to remove it.
2. Remove the paper tray cover.
3. Pinch the tabs of the bottom fence then slide it completely forward.
4. Fan a stack of paper to remove static cling.
5. Load the paper into the cassette.
6. Add paper until it as far as the load limit marks .
To prevent paper jams, never load paper higher than the load limit mark.
7. Pinch the tabs of the bottom fence . Then move it to the edge of the stack.
8. Make sure the top of the stack is perfectly flat. Do this if the top of the stack
bends upward:
9. Adjust the positions of the side fences and bottom fence.
10. Reattach the paper tray cover .
11. Slowly insert the paper tray into the printer.
12. Make sure that the paper tray is correctly inserted.
J007/J010/J011
CÓPIA NÃO CONTROLADA
1-22
CÓPIA NÃO CONTROLADA
SM