Ricoh J001 Service Manual page 230

(4) The ac power supply is not within range approved for
operation of the printer.
(5) ST Descriptions
5-1 Operation impaired by other causes.
8.3.15 COVER OPEN/DUPLEX UNIT
SERVICE CENTER CALL RESPONSE
Cover open
A cover is open, the duplex unit is not set, or it is not set
correctly.
(1) Check the printer covers to determine whether they have
been left open.
(2) Check the rear cover to determine whether it has been left
open.
(3) Make sure the following items are set correctly.
3-1 Duplex unit cover (J001)
3-2 Duplex unit (J003)
(4) ST Descriptions
4-1 Operation impaired by other causes.
8.3.16 PRINT HEAD CLEANING IN PROGRESS
SERVICE CENTER CALL RESPONSE
Print head is undergoing "Normal" or "Full" cleaning.
The print heads are being cleaning from the printer driver, the
print heads are being cleaned because the printer has been idle.
(1) After "Normal" or "Full" cleaning has finished, make sure the
printer goes online and is ready for normal operation.
8.3.17 READY
SERVICE CENTER CALL RESPONSE
Printing...
A print job is in progress.
(1) After the print job is finished, make sure the printer goes
online and is ready for normal operation.
8.3.18 READY/RESET
SERVICE CENTER CALL RESPONSE
Print job reset.
The [Cancel] key has been pressed and the printer is erasing (a
SM
CÓPIA NÃO CONTROLADA
Power surge occurred. Power drop occurred.
1 Harness disconnected, damaged.
2 Replace control board (NRC).
PROBABLE CAUSE
1 A printer cover is not closed.
2 Rear cover is not closed.
3 The duplex cover is open, or duplex unit is not installed
correctly.
4 Damaged.
A printer cover is not closed.
A printer cover is not closed.
1 The duplex unit cover is not closed (J001).
2 The duplex unit cover is not set correctly (J003).
1 Harness disconnected, damaged.
2 Interlock switch damaged.
PROBABLE CAUSE
"Normal" or "Full" print head cleaning is in progress.
"Normal" or "Full" print head cleaning is in progress.
PROBABLE CAUSE
A print job is in progress.
Printing...
PROBABLE CAUSE
Deleting print job data (resetting the printer).
8-30
CÓPIA NÃO CONTROLADA
Check the rating of the input voltage.
OPERATOR ACTION
Close the printer covers.
Close the rear printer cover.
1 The duplex unit cover is not closed (J001).
2 The duplex unit is not set correctly (J003).
OPERATOR ACTION
Wait for the printer to go online after the "Normal" or "Full"
cleaning has finished.
OPERATOR ACTION
Wait for the printer to enter the "Ready" mode after print job
is finished.
OPERATOR ACTION
J001/J003