Ricoh J001 Service Manual page 249

8.4.9 OTHER
Service Center Call
Event
Response
LEDs flashing Switch the printer off/on, and if
this does not solve the problem,
repair.
Power does not (1) Make sure that the power
switch on. cord is connected correctly.
(2) Press the [Power] key down
and hold it down.
(3) Disconnect the power cord
and wait for at least 2 min.,
then connect the power cord
again and switch the printer
on.
(4) If the printer does not
recover after doing the
above procedures, repair
the printer.
(5) If this problem occurs
frequently, contact the
repair depot.
Printer loses
power while
printing
Power down (1) Switch the printer on.
due to non-
rated power (2) If this problem occurs
supply frequently, update the printer
firmware.
No error (1) May occur in standby mode. In standby mode (cut 37 V dc power
displayed even
though cover is
open
(2) Switch the printer off/on.
(3) Open the cover again to
determine if the error is
displayed.
SM
CÓPIA NÃO CONTROLADA
Probable Cause
Connectors loose.
Power cord not connected. Power cord connection.
Press and hold down the [Power] key Hold down the [Power] key slightly
for about 1 sec. longer.
The power output safety circuit opened. Disconnect the power cord from the
power source, wait for at least 2 min.,
the connect the cord again and switch
the printer on.
The power output safety circuit opened. Disconnect the power cord from the
Output signal short power source, wait for at least 2 min.,
the connect the cord again and switch
the printer on.
Switch the printer on.
Software (Assert) If this problem occurs frequently, update
System down (Undefined exception, the printer firmware.
stack overflow, etc.)
Check the printer information log.
May occur in standby mode.
supply) .
Switch the printer off/on
Open the cover again to determine if the
error is displayed.
CÓPIA NÃO CONTROLADA
Operator Action
Set the connectors under the LED cover.
Power cord connection.
Hold down the [Power] key slightly longer.
Disconnect the power cord from the power
source, wait for at least 2 min., then connect the
cord again and switch the printer on.
If the printer does not recover, repair it.
If the printer does not recover, repair it.
If the printer does not recover, repair it.
Disconnect the power cord from the power
source, wait for at least 2 min., then connect the
cord again and switch the printer on.
If the printer does not recover, repair it.
Send the acquired information to the repair depot
for analysis.
Send the acquired information to the repair depot
for analysis.
8-49
Problem Solution
Content User ST
X
X
X
X
X
X X
X X
X X
X X
X X
J001/J003
NRC
X
x
x
X
X
X
X
X
X