(3) If the spooling operation is no longer in
progress, do the procedure below.
3-1 Disconnect the USB cable.
3-2 Switch printer power off/on
3-3 Cancel the print job on the PC.
3-4 Reboot the PC.
(4) ST Descriptions
4-1 Operation impaired by other causes.
SM
CÓPIA NÃO CONTROLADA
Control board defective.
CÓPIA NÃO CONTROLADA
If the spooling operation is no longer in progress,
do the procedure below.
1. Disconnect the USB cable.
2. Switch printer power off/on
3. Cancel the print job on the PC.
4. Reboot the PC.
8-25
Replace control board (NRC).
J001/J003