Ricoh 920F Operating Instructions Manual page 1234

Problem
"Temperature Alert. Turn
main power off, adjust room
temp. and wait a while before
restarting." appears, and
printing is disabled.
"You do not have the
privileges to use this function."
appears.
An error message remains,
even if misfed paper is
removed.
Original images are printed
on the reverse side of the
paper.
Misfeeds occur frequently.
Misfeeds occur frequently.
Cannot print in duplex mode. Duplex printing cannot be
Cause
The temperature inside the
machine is too high or too
low.
The use of the function is
restricted to authenticated
users only.
• When a misfeed
message appears, it
remains until you open
and close the cover as
required.
• Paper is still jammed in
the tray.
You may have loaded the
paper incorrectly.
The tray's side or end fences
may not be set properly.
Copy paper size setting is not
correct.
done with paper set in the
bypass tray.
When You Have Problems Operating the Machine
Solution
Locate the machine in an environment
where the temperature remains between
10 and 32°C. See "Where to Put Your
Machine", About This Machine
Contact the administrator about the
permission for the required function.
Remove misfed paper, and then open
and close the cover. See p.93
"Removing Jammed Paper".
Load paper correctly. Place paper in the
paper tray with the print side up. Bypass
tray with the print side down. See
"Loading Paper", About This Machine
.
• Remove the misfed paper. See
p.93 "Removing Jammed
Paper".
• Check the side or end fences are
set properly. Also, check the side
fences are locked. See "Changing
the Paper Size", About This
Machine .
Set the proper paper size. See "Tray
Paper Settings", Network and System
Settings Guide and "Recommended
Paper Sizes and Types", About This
Machine .
When using duplex printing, make
settings to use paper from a tray other
than the bypass tray.
1
.
17