Messages Displayed On The Client Computer - Ricoh 920F Operating Instructions Manual

Message
"You do not have privileges to
use this function."

Messages Displayed on the Client Computer

This section describes likely causes of and possible solutions for the main error messages displayed on the
client computer when using the TWAIN driver.
• If a message not described here appears, act according to the message. For information about how
to turn off the main power switch, see "Turning On/Off the Power", About This Machine
Message
"Any of Login User Name,
Login Password or Driver
Encryption Key is incorrect."
"Cannot add any more
scanning mode."
"Cannot connect to the
scanner. Check the network
Access Mask settings in User
Tools."
"Cannot find "XXX" scanner
used for the previous scan.
"YYY" will be used instead."
("XXX" and "YYY" indicate
scanner names.)
Cause
Privileges to use this function. Contact the administrator.
Cause
The entered login user name,
password, or driver
encryption key was invalid.
The maximum number of
registerable scan modes has
been exceeded.
An access mask is set.
The main power switch of the
previously used scanner is not
set to "On".
Messages Displayed When Using the Scanner Function
Solution
Solution
• Check the login user name, login
password, and driver encryption
key.
• Permission to use this function has
not been granted. Contact the
administrator.
The maximum number of modes that can
be stored is 99. Delete unneeded
modes.
Contact the network or scanner
administrator.
Check whether the main power switch of
the scanner used for the previous scan is
turned on.
.
5
89