Ricoh 920F Operating Instructions Manual page 1292

Problem
Solid lines are printed as
broken lines.
Optional components
connected to the machine are
not recognized when using
Windows 2000/XP/Vista,
Windows Server
2003/2003R2/2008.
When using Windows
2000/XP/Vista, Windows
Server
2003/2003R2/2008,
Auto Reduce/Enlarge print
does not come out as
expected.
The print job is not canceled
even when the machine is
switched to offline status.
Images are incomplete, or
excess pages are printed.
Cause
Dither patterns do not match. Make the following settings with the
Bidirectional communication
is not working.
-
-
You may be using paper
smaller than the size selected
in the application.
Other Printing Problems
Solution
printer driver:
• Only when using PostScript 3
Change the [Dithering] setting in
the [Print Quality] on the [Detailed
Settings] tab.
Set up optional devices on the Properties
of the machine.
See the printer driver Help.
Make sure the application's paper size
and orientation settings match those of
the printer driver.
If a different paper size and orientation
are set, select the same size and
orientation.
Even when the machine is offline,
printing is performed when [Job
Acceptance Priority] is selected for
[Signal Control] in [Parallel Interface] in
[Interface Settings] under [System
Settings]. Select [Printer Priority] for
[Signal Control].
See "Interface Settings", Network and
System Settings Guide
Use the same size paper as that selected
in the application. If you cannot load
paper of the correct size, use the
reduction function to reduce the image,
and then print.
See the printer driver Help.
4
.
75