Removing The Oil Pressure Regulator Valve; Checking Spring Length Of Oil Pressure Regulator Valve - Husqvarna FC 450 2014 Repair Manual

17 ENGINE
17.4.3

Removing the oil pressure regulator valve

17.4.4

Checking spring length of oil pressure regulator valve

-
Press the shaft seal ring @ of the crankshaft from the outside to the inside with
the open side facing out.
• Info
I
The shaft seal ring must be flush on the outside.
-
Press in the shaft seal ring
shift shaft with the open side facing inward until it is flush.
-
Position membrane support plate
-
Mount and tighten screws
Guideline
Screw, membrane
-
Position membrane support plate
-
Mount and tighten screws
Guideline
Screw, membrane
-
Position oil spray tube
-
Mount and tighten screw
Guideline
Screw, oil spray tube
-
Mount the dowels.
-
Blow compressed air through all oil channels and check that they are clear.
Remove screw plug
-
Remove pressure spring
304671-10
Preparatory work
-
Remove the oil pressure regulator valve. (..- p. 145)
0
of the countershaft and shaft seal ring
@)
together with the membrane.
@).
1.5 Nm
M3
(1.11 lbf ft)
8
together with the membrane.
CD.
M3 1.5 Nm
(1 .11 lbf ft)
8.
O.
M4 5 Nm
(3.7 lbf ft)
O 8.
with sealing washer
e.
CD
and ball
145
(D
of the
Loctite 243
® ™
Loctite 243
® ™
Loctite 243
® ™