Engine Removal; Engine Locking; Cooling Sleeve, Intake Flange, And Ignition Coil Removal; Ignition Cover Removal - Husqvarna CR 50 / 2011 Workshop Manual

ENGINE

ENGINE DISASSEMBLY

Engine locking

- Thoroughly clean engine before disassembly.
- You can vice engine locking rear support with protective jaws (see pic-
ture).

Cooling sleeve, intake flange, and ignition coil removal

- Loosen hose clamps and disconnect water sleeve (2).
- Slide pin (3) out of ignition coil, remove cap from spark plug.
- Loosen the 4 screws on intake flange (4); remove ignition coil with support,
intake flange and reed unit.
- Remove spark plug.

Ignition cover removal

- Loosen screws (5) and remove ignition cover.
Water pump (6) is positioned outside, onto ignition cover.
- Ignition cover is centred thanks to two centring bushings that usually stay
inside engine crankcase, and should be removed using suitable pliers.
Water pump features a hole housing a spring (7).
F.6
Ed. 01-09-2010