Front Brake Master Cylinder - Suzuki VZR1800K6 Service Manual

THROTTLE
Insert the boss of the throttle housing into the hole on
the handlebars.
Tighten the throttle assembly with two screws.
Check to ensure that the throttle operates
freely and closes automatically.
A: Boss
B: Hole
C: 5 × 45 mm screw
D: 5 × 35 mm screw

FRONT BRAKE MASTER CYLINDER

Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the master cylinder mounting bolts to the
specified torque.
Front brake master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
bolt C of the upper side with specified torque
and then tighten the bolt D of the lower side.
A: Holder
B: Front brake master cylinder
C: 6 × 20 mm Allen bolt
D: 6 × 20 mm Allen bolt
E: Dot mark
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
A: Bolt
B: Holder
C: Front brake master cylinder
D: Handlebars
7
10 N·m (1.0 kgf-m, 7.0 lb-ft)