NEC Univerge SV8100 Features And Specifications Manual page 1879

UNIVERGE SV8100
Dial this Service Code. . .
1
Except where indicated, dial Service Code from Intercom dial tone (e.g., press idle Speaker first).
#5
#6 + orbit (01~64)
#7
#8
#9 + 001 -200
0 (Off-Hook)
1 (Off-Hook)
4 (On-Hook)
6 (On-Hook)
8 (On-Hook)
9
600 + code + 0
601 + code + 0
602 + Group number
(1~8 or 01~64)
603 + Group number
(1~8 or 01~64)
Features and Specifications Manual
Table 3-2 Service Codes by Number (Continued)
1
When you . . .
Use Last Number Redial.
Park a call in a system Park
orbit (1~8, 01~32 or 01~64).
Use Personal Speed
dialing.
Set up an Unsupervised
Conference.
Place a call over a specific
trunk.
Leave a Message Waiting at a
co-worker's busy or
unanswered extension.
Change the signaling mode of
your outgoing Intercom call.
Listen to the General Message.
Check an extension number.
Listen for the time.
Place a call using ARS or Trunk
Group Routing.
Use Dial Block.
Aa a supervisor use Dial Block.
Set Automatic Transfer Setup
for each extension group.
Cancel Automatic Transfer
Setup.
For this feature. . .
Last Number Redial
Park
Speed Dialing
Tandem Trunking
(Unsupervised
Conference)
Central Office Calls,
Placing
Message Waiting
Handsfree
Answerback/Forced
Intercom Ringing
Voice Response
System (VRS)
Voice Response
System (VRS)
Voice Response
System (VRS)
Automatic Route
Selection
Trunk Group Routing
Toll Restriction, Dial
Block
Toll Restriction, Dial
Block
Transfer
Transfer
Issue 8.01
Also see
Function Key. . .
-
04 + orbit

(1~64)
-
-
01 + trunk

(001~200)
35
-
-
-
-
02

-
-
-
-
3 - 5