Caller Id - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

Enhancements

Pressing the Left Cursor Key twice (on equipped terminals) displays the Incoming Call History

(Version 3000 or higher software).

With Version 4000 (4.01 or higher) software, calls to a busy extension or busy tones returned to the

caller are logged in the Caller ID List. When a busy call is logged, the Caller ID List key flashes the

same as it does with a new missed call.

Caller ID allows a display terminal to show an incoming caller's telephone number (called the Directory

Number or DN) and optional name. The Caller ID information is available as pre-answer display. With

the pre-answer display, the user previews the caller's number before picking up the ringing line.

On the CD-CP00-US for Caller ID (also used for DTMF receivers and Call Progress Tone Detection) 32 resources are

available. The PZ-BS10 provides an additional 64 resources.

Second Call Display

While busy on a call, the telephone display can show the identity of an incoming trunk or Intercom call.

For incoming trunk calls, the display shows the Caller ID or ANI data or the trunk name if Caller ID or ANI

are not installed. (Refer to

information on ANI compatibility.) For incoming Intercom calls, the display shows the calling extension

Caller ID supports the Telco Called Number Identification (CNI) and Called Number Delivery (CND)

service, when available. These services provide the Caller ID information (i.e., messages) between the

first and second ring burst of an incoming call. Two types of Caller ID message formats are currently

available: Single Message Format and Multiple Message Format. With Single Message Format, the

Telco sends only the caller's telephone number (DN). The DN has seven or 10 digits. In Multiple

Message Format, the Telco sends the DN and the caller's name. The DN for this format also has seven

or 10 digits, and the name provided consists of up to 15 ASCII characters.

The telephone display can show up to 12 Caller ID digits (for non-ACD calls).

Once installed and programmed, Caller ID is enabled for all trunk calls, including:

Ring Group calls

Calls transferred from another extension

Calls transferred from the VRS

Calls transferred from Voice Mail (unscreened)

Caller ID

T1 Trunking (with ANI/DNIS Compatibility) on page 2-1365