NEC Univerge SV8100 Features And Specifications Manual page 138

Issue 7.0
Speed Dial – System/Group/Station
Trunk Group Routing
Trunk Queuing/Camp On
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-01-01 System Numbering
11-09-01 Trunk Access Code
11-09-02 2nd Trunk Route Access Code
12-01-01 Night Mode Function Setup –
Manual Night Mode Switching
2 - 110
Description/Comments
Set the system internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this
program to tailor the system
numbering to the site.
Specify the digit or digits to be
used to access ARS (normally 9).
Define additional trunk access
codes.When a user dials the
Alternate Trunk Route Access
Code, the system routes their call
to the Alternate Trunk Route.
Turn Off or On any extension from
activating Manual Night Service.
UNIVERGE SV8100
Assigned Data
1
Refer to SV8100
Programming Manual
for a detailed
description of this
program.

Dial up to four digits
(default = 9)
Dial up to four digits
(default not assigned)
0 = Off
1 = On
(default = 1)
Automatic Route Selection
Level
2 3


