Removing The Reflector Assembly; Replacing The Uv Filter - Christie CP2208 Service Manual

4. Remove the two screws securing the lamp adjust assembly to the center structure.
5. Disconnect the X Y Z cables from the lamp adjust assembly.
6. Disconnect the cathode lead connector from the lamp power supply.
7. Tip the lamp adjust assembly toward the front of the projector and then slide it past the
reflector and out of the lamp access door.
8. Disconnect the cathode lead connector from the lamp adjust assembly and set it aside. You will
reuse the cable when you install the new lamp adjust assembly.

Removing the reflector assembly

Wear clean, lint-free gloves when removing the reflector assembly.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the lamp. See
4. Remove the touch panel controller (TPC). See
34.
5. Remove the anode blower and firewall. See
6. Remove the two screws securing the fire warning sensor.
7. Remove the two P-clips from the fire warning sensor bracket and push the bracket aside.
8. Remove the four screws that secure the reflector module. Three of these screws are located on
the bracket outside the reflector. The fourth screw is located inside the casing below the
reflector.
9. Carefully lift the reflector assembly straight up and out of the projector; do not touch the UV
filter glass or the reflector.

Replacing the UV filter

Wear clean, lint-free gloves, and handle the UV filter by its edges.
The UV filter is secured to the end of the light tube. If a lamp explodes, the UV filter must be
replaced.
1. Turn the projector off and then disconnect it from AC power.
2. Open the lamp access door.
3. Remove the top lid. See
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Removing the existing lamp
Removing the anode lamp firewall
Removing the top lid
Parts and Module Replacement
on page 33.
on page 40.
Removing the touch panel controller
on page 33.
on page
.
on page 45
48