Reflectors (Including Heat Dump) - Christie CP4230 Service Manual

Section 5: Parts and Module Replacement

5.12.9 Reflectors (Including Heat Dump)

In the event of a lamp explosion, both glass reflectors will be permanently damaged and need replacement. It is
also likely that the metal reflector shield for the rear reflector will be damaged as well.
(Estimated Replacement Time: 90 minutes + 10 minute LampLOC™ Alignment)
1. Open the lamp door. Refer to
2. Remove the lamp (if installed). Refer to
3. Remove the front top lid. Refer to
4. Remove the rear top lid. Refer to
5. Remove the thermal sensor harness and interlock harness from the exhaust interlock assembly.
6. Using a 7mm nut driver remove the nut inside the housing before removing the screw on the external metal
duct plate, shown in Figure 5-64.
7. Use a 3mm hex key to remove the six other screws on the duct. (Figure 5-65)
8. Remove the douser assembly. Refer to
5-44
5.4.8 Lamp Door, on page
5.12.5 Lamp Replacement, on page 5-38.
5.4.2 Front Top Lid, on page
5.4.12 Rear Top Lid, on page
Figure 5-64 Remove External Metal Duct
Figure 5-65 Remove Screws Securing Duct
5.12.4 Igniter, on page
5-9.
5-6.
5-11.
5-37.
CP4230 Service Manual
020-100622-04 Rev. 1 (05-2016)