Section 5: Parts and Module Replacement
5.2.36DMD Heat Pipe Assembly
Replacement Time: 80 minutes
Procedure:
1. Remove Light Engine. See
2. Remove Foam Block.
3. Peel back Copper Tape.
4. Remove spring loaded screws (4). See Figure 5-56.
5. Carefully lift off Heat Pipe Assembly.
6. Replace Heat Pipe Assembly.
5.2.37DMD
Replacement Time: 85 minutes
1. Remove Light Engine. See
2. Remove DMD Heat Pipe Assembly. See
3. Remove Dynamic Aperture. See
4. Remove screws (4). See Figure 5-57.
5. Lift off DMD Board.
6. Remove DMD from Light Engine.
7. Replace DMD.
5-32
5.2.33 Light
Engine.
F
5-56 R
DMD H
IGURE
EMOVE
Engine. NOTE: Follow entire procedure.
5.2.33 Light
5.2.36 DMD Heat Pipe
5.2.32 Dynamic
F
5-57 R
IGURE
P
A
EAT
IPE
SSEMBLY
Assembly.
Aperture.
DMD
EMOVE
E Series 675/775 Service Manual
020-000546-04 Rev. 1 (04-2017)