Reflectors And Heat Dump - Christie CP2420-Xe Service Manual

2. Remove the lamp (on page 74).
3. Remove the back cover (on page 51).
4. Disconnect the main AC blower power harness.
5. Remove the four screws securing the blower to the mounting bracket.
6. Carefully remove the fan out the top of the projector.
7. To re-install, follow these steps in reverse order.
8. Perform LampLOC

Reflectors and heat dump

Learn how to remove the reflectors and heat dump.
Warning! If not avoided, the following could result in death or serious injury.
• This procedure must be performed by Christie qualified technicians.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
• EXPLOSION HAZARD! Always wear manufacturer approved protective safety clothing (gloves,
jacket, face shield) whenever the lamp door is open or when handling the lamp. Any local or
federal specifications take precedence over Christie's protective clothing recommendations.
1. Remove the lamp door (on page 53).
2. Remove the lamp (on page 74).
3. Remove the back cover (on page 51).
4. Remove the four screws securing the reflector casting to the baseplate.
CP2420-Xe and CP4420-Xe Service Guide
020-103566-02 Rev. 1 (07-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
™ alignment (on page 21).
Lamp compartment
84