Removing The Exhaust Panel Skin; Removing The Safety Shield - Christie CP2208 Service Manual

5. Push the clips on the top of the service panel down and out to remove the service panel.

Removing the exhaust panel skin

The exhaust panel is located on the left when facing the rear of the projector. The exhaust panel
skin includes the service panel that you can remove separately to access to optical components.
The exhaust panel skin rarely needs to be replaced because you can remove the side skin service
door to access internal components.
1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the service door. See
4. Loosen the three screws from the bottom of the exhaust panel skin.
5. Remove the top four hex screws.
6. Pull the skin forward and out.

Removing the safety shield

Warning! Failure to comply with the following could result in serious injury.
UV HAZARD! Always wear protective safety clothing and a face shield when performing service with
the safety shield removed and a lamp installed.
The safety shield is positioned above the lamp reflector and is used to block UV light.
1. Turn the projector off and then disconnect it from AC power
2. Remove the top lid. See
3. Loosen the two captive screws.
4. Pull the safety shield (A) up and outward from the locking tabs.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the top lid
Removing the service door
Removing the top lid
Parts and Module Replacement
on page 33.
on page 38.
on page 33.
A
39