Removing The Exhaust Panel Skin - Christie CP2208-LP Service Manual

6. Remove the screw from the AC receptacle.
7. Remove the nut and washer securing the ground lug to the projector and then remove the
ground lug.
8. Pull on both sides of the rear skin to clear the corner brackets and pull towards you.
9. Remove the two screws securing the TPC harness connector.
10. Remove the rear skin.
11. To re-install, complete these steps in reverse order.

Removing the exhaust panel skin

The exhaust panel skin provides access to optical components. It is located on the left-hand side when
you are facing the rear of the projector.
Estimated replacement time: 15 minutes
1. Turn off the projector and then disconnect it from AC power.
2. Remove the top skin (on page 32).
3. Remove the rear skin (on page 37).
4. Remove the two screws securing the skin to the corner bracket.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Projector covers and feet
38