Remove The Rear Skin; Remove The Exhaust Panel Skin - Christie CP2215 Service Manual

Parts and Module Replacement

Remove the Rear Skin

The rear access frame interlocks with the side skins.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the touch panel controller (TPC). See
5. Remove the safety shield. See
6. Remove the 5 screws from the bottom edge of the skin.
7. Remove the 2 screws from the AC receptacle.
8. Open the lamp door.
9. Remove the 4 screws securing the rear skin to the projector chassis.
10. Remove the standby cable harness from the 6 P-clips.
11. Loosen the spring screw holding the standby power supply to the rear skin.
12. Disconnect the AC harness connector.
13. Remove the standby power supply and set it on the top of the projector.
14. Carefully pull the top of the rear skin outward so it clears the tabs.
15. Disconnect the 2 lamp door switch connectors.
16. Remove the interlock harness from the 2 P-clips.
17. Disconnect the LED harnesses and remove them from the P-clips.
18. Remove the 2 screws securing the standby power supply bracket to the rear skin.
19. Remove the 2 screws securing the TPC harness to the rear skin.
20. Remove the TPC harness from the 4 P-clips.
21. Carefully pull the top of the skin outward and remove the screw from the cable clip.
22. Remove the nut and washer securing the ground lug to the projector and then remove the
ground lug.
23. Pull the skin forward and out.

Remove the Exhaust Panel Skin

The exhaust panel is located on the left when facing the rear of the projector. The exhaust panel skin
includes the service door that you can remove it separately to access to optical components. The
exhaust panel skin rarely needs replacement because you can remove the side skin service door to
access internal components.
1. Turn the lamp off and cool the projector for at least 15 minutes.
26
Remove the Top Lid on page 22.
Remove the Touch Panel Controller
Remove the Safety Shield on page 27.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)
on page 23.