Install Top Cover; Figure 2-5 Installing The Top Cover - Overland Storage PowerLoaders AIT-2 User & Installation Manual

S U R M
ETTING P THE ACK OUNT

Install Top Cover

With the tabletop cover removed, install a sheet metal top cover that protects the
PowerLoader™ interior components when mounted in a rack
1) Place the top cover over the PowerLoader™ chassis top with each side flange to the outside of
the chassis.
2) Slide the cover forward until it is flush with the front panel.
3) Fasten the cover with two screws (4M x 8mm).
4) Remove the four rubber feet on the bottom of the PowerLoader™.
u
2-6 Installation
M
ODEL
Slide Flanges
Side Flanges
Figure 2–5. Installing the Top Cover
(Figure 2–5).
LP-0011