Enable Interface; Enable Ip Ospf - Zte ZXR10 8900 Series Command Reference Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
disable area

enable interface

Use this command to enable the disabled interfaces in the specified
range. It is ineffective for the enabled interfaces.
Router configuration
enable interface <ip-address><wildcard-mask>
<ip-address>
<wildcard-mask>
If this area has been configured, it is valid by default.
This command is supported after the platform version 4.6.02.
This example enables interface addresses of the network 10.1.0.0.
ZXR10(config)#router ospf 1
ZXR10(config-router)#enable interface 10.1.0.0 0.0.255.255
disable interface

enable ip ospf

Use this command to enable the OSPF protocol if it is disabled.
Otherwise, the command is ineffective.
Global configuration
enable ip ospf <process-id>
<process-id>
If the OSPF protocol has been configured, it is enabled by default.
This command is supported after the platform version 4.6.02.
This example enables OSPF process 1.
ZXR10(config)#enable ip ospf 1
Confidential and Proprietary Information of ZTE CORPORATION
IP address, in the form of dotted decimal
Wildcard mask, in the form of dotted decimal
OSPF process ID, namely, the configured
OSPF instance number, range: 1~65535
Chapter 3 OSPF Protocol
51