Configuring Ldp Time Parameters; Configuring Md5 Password; Clearing Lsr Peer Connection - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (MPLS Volume)
St- Command
ep
1
ZXR10(config)#
<prefix-access-list>| host-route-only}
2
ZXR10(config)#
abel>
3
ZXR10(config)#
<prefix-access-list>[to <peer-access-list>]]
St- Command
ep
1
ZXR10(config)#
<holdtime>| interval <interval>}
2
ZXR10(config)#
3
ZXR10(config)#
ximum-backoff>
Command
mpls ldp neighbor <ip-address>
ZXR10(config)#
password <password>
20 Confidential and Proprietary Information of ZTE CORPORATION
mpls ldp access-fec {for
mpls label range <min-label><max-l
mpls ldp advertise-labels [for

Configuring LDP Time Parameters

To configure LDP time parameters, perform the following steps.
mpls ldp discovery hello {holdtime
mpls ldp holdtime <seconds>
mpls ldp backoff <initial-backoff><ma

Configuring MD5 Password

To configure MD5 password, use the following command.

Clearing LSR Peer Connection

To clear and re-establish a LSR peer connection, use the following
command.
Function
This configures the labels for
network segments LDP can
generate
This sets usable label range
of LDP
This controls LDP distribute
labels
Function
This configures interval for
sending LDP hello message
between LSRs that connect
directly and indirectly
This configures the holding
time when a LDP session can
not receive successor LDP
messages
This configures the
parameters of backing
off re-establishing mechanism
for LDP sessions
Function
This configures MD5 password