Auto-Summary; Default-Metric - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (IP Routing Volume I)
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Purpose
Command Modes
Syntax
10 Confidential and Proprietary Information of ZTE CORPORATION
Router configuration
address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf <vrf-name>
<vrf-name>
Invalid
The RIP extension supports the VRF address mode. The corre-
sponding address configuration mode should be entered to config-
ure the address mode.
This example describes how to enter the vpn1 address mode.
ZXR10(config)#router rip
ZXR10(config-router)#address-family ipv4 vrf vpn1
ZXR10(config-router-af)#

auto-summary

Use this command to configure to send the route which only passes
through the summarized nature network and super network routes
(in RIPV2). To send all RIP routes, use the no command.
Router configuration and address family configuration

auto-summary

no auto-summary
Enable
� The route summary reduces the route information volume to
be sent.
� Even if the command auto-summary is configured, Please
mention the following policies which are still effective:
Router has an interface address and this interface address in
a natural network segment, which is a sub network segment
of RIP protocol. RIP update packet sends from this interface
without natural network routing, but with other RIP sub net-
work routings, which belong to a different sub network with
the interface.

default-metric

Use this command to re-distribute the other protocol generated
routes as the default metric for the RIP route. To restore default,
use the no command.
Router configuration and address family configuration
default-metric <metric-value>
no default-metric
VRF name, 1~16 characters